Printer Функции
PHP Manual

printer_draw_pie

(No version information available, might be only in CVS)

printer_draw_pie — Draw a pie

Описание

void printer_draw_pie ( resource $printer_handle , int $rec_x , int $rec_y , int $rec_x1 , int $rec_y1 , int $rad1_x , int $rad1_y , int $rad2_x , int $rad2_y )

The function draws an pie.

Список параметров

printer_handle

printer_handle must be a valid printer handle.

rec_x

rec_x is the upper left x coordinate of the bounding rectangle.

rec_y

rec_y is the upper left y coordinate of the bounding rectangle.

rec_x1

rec_x1 is the lower right x coordinate of the bounding rectangle.

rec_y1

rec_y1 is the lower right y coordinate of the bounding rectangle.

rad1_x

rad1_x is x coordinate of the first radial's ending.

rad1_y

rad1_y is y coordinate of the first radial's ending.

rad2_x

rad2_x is x coordinate of the second radial's ending.

rad2_y

rad2_y is y coordinate of the second radial's ending.

Возвращаемые значения

Эта функция не возвращает значения после выполнения.

Примеры

Пример #1 printer_draw_pie() example

<?php
$handle = printer_open();
printer_start_doc($handle, "My Document");
printer_start_page($handle);

$pen = printer_create_pen(PRINTER_PEN_SOLID, 2, "000000");
printer_select_pen($handle, $pen);

$brush = printer_create_brush(PRINTER_BRUSH_SOLID, "2222FF");
printer_select_brush($handle, $brush);

printer_draw_pie($handle, 1, 1, 500, 500, 1, 1, 500, 1);

printer_delete_brush($brush);
printer_delete_pen($pen);

printer_end_page($handle);
printer_end_doc($handle);
printer_close($handle);
?>

Коментарии

404 Not Found

404 Not Found

nginx
Printer Функции
PHP Manual
    Поддержать сайт на родительском проекте КГБ