curl_pause
(PHP 5 >= 5.5.0, PHP 7)
curl_pause — Pause and unpause a connection
Описание
int curl_pause
( resource
$ch
, int $bitmask
)
Внимание
К настоящему времени эта функция еще не была документирована; для ознакомления доступен только список аргументов.
Список параметров
-
ch -
Дескриптор cURL, полученный из curl_init().
-
bitmask -
One of
CURLPAUSE_*constants.
Возвращаемые значения
Returns an error code (CURLE_OK for no error).
- PHP Руководство
- Функции по категориям
- Индекс функций
- Справочник функций
- Другие службы
- Клиентская библиотека работы с URL
- curl_close
- curl_copy_handle
- curl_errno
- curl_error
- curl_escape
- curl_exec
- curl_file_create
- curl_getinfo
- curl_init
- curl_multi_add_handle
- curl_multi_close
- curl_multi_exec
- curl_multi_getcontent
- curl_multi_info_read
- curl_multi_init
- curl_multi_remove_handle
- curl_multi_select
- curl_multi_setopt
- curl_multi_strerror
- curl_pause
- curl_reset
- curl_setopt_array
- curl_setopt
- curl_share_close
- curl_share_init
- curl_share_setopt
- curl_strerror
- curl_unescape
- curl_version
Коментарии
http://curl.haxx.se/libcurl/c/curl_easy_pause.html
Using this function, you can explicitly mark a running connection to get paused, and you can unpause a connection that was previously paused.
A connection can be paused by using this function or by letting the read or the write callbacks return the proper magic return code (CURL_READFUNC_PAUSE and CURL_WRITEFUNC_PAUSE). A write callback that returns pause signals to the library that it couldn't take care of any data at all, and that data will then be delivered again to the callback when the writing is later unpaused.
NOTE: while it may feel tempting, take care and notice that you cannot call this function from another thread.
When this function is called to unpause reading, the chance is high that you will get your write callback called before this function returns.
The handle argument is of course identifying the handle that operates on the connection you want to pause or unpause.
The bitmask argument is a set of bits that sets the new state of the connection. The following bits can be used: